|
| |
NTpage Watcher Command Line Options
|    |
If you need to debug NTpage Watcher, you can run the program in Debug mode by entering the following command from a command prompt:
NTPWATCH debug
Other command line parameters are similar to NTPSERVE.EXE as follows:
| - -install
(installs into service manager and sets startup to manual)
- -ainstall
(installs into service manager and sets startup to automatic)
- -start
(starts the service)
- -stop
(stops the service)
- -remove
(removes from NTpage Watcher from the service manager)
|
|
