 ani | The ANI or callers number. Digit portion of the Caller ID. |
| busy | Flag to indicate that this channel is working on a call. |
| busyOutStatus | Allows TMonitor To Busy Out This Port |
| callEnd | The time when this call ended. |
| callerIDName | For PRI or GlobalCall, you may receive the callerID name. |
| callNumber | The number assigned to this call. |
| callStart | The time when this call was started |
| chdev | The CTI32 voice resource device. Use this for Play, Record, GetDigits, Dialing tones etc. |
| dbConnection | Database information needed to access the database. |
| defaultDID | For an analog applications, if the DNIS (DID) is not available, it will pass this value as the DID. This allows you to have a different application on each analog phone line. |
| dialMask | The dialmask this port is to use. Leave empty for no dial mask |
| did | The DID (DNIS) of the current call. This is the called number. (the dialed number) |
| globalCallProtocol | The Protocol Used For This Board |
| inboundReady | You can use this in your application in synchronizing a transfer or route that the inbound side is ready. |
| incomingCall | Function to call when an incoming call arrives. |
| index | The index in the cfg.ChannelData structure that is this port |
| isOutbound | Flag to indicate that an outbound call is requested. |
| isRecording | TMonitor Recording Information |
| lineType | See cti.LineType enum. PRI, T1, ANALOG, MSI, PBX |
| log | The log object for file logging and monitor |
| mask | This mask is used to determine how to parse incoming DTMF tones on T1 lines during call set up. |
| method | Outbound method to call |
| module | Outbound DLL to call |
| namespaceDotClass | Type of call Namespace.Class |
| openName | The dialogic port name. Name to open the port. This is for the voice resource side of the board. i.e. dxxxB1C1 |
| port | This is the port number for this channel. It is assigned by the ID in the cti32engine.config file. |
| rawDigits | The raw DID/DTMF digits that come in on a T1 line |
| recordedByPort | More TMonitor Recording Information |
| shutdown | Flag that specifies the thread should shutdown. |
| startWait | The time when we started waiting for the call |
| syncVar | An object to synchronize locks with |
| t1dev | The CTI32 DTI line side (channel side) device. Use this for SetHook, Route, (Dial for ISDN) etc. |
| t1Name | The dialogc port name, DTI side or channel side of the board. i.e. dt1B1T1. For analog cards the openName and t1Name will be the same. |
| transferState | You can use this in your application to indicate whether you have transferred a call. |
| twoWay | Is the line specified as IN, OUT, or INOUT. see cti.TwoWay enum |
| userData | User Data to pass to the outbound thread |
| vapHandle | The engine stores the file handle to the open VAP file here |
ChannelData Constructor
Finalize (inherited from Object)